How to setup Door Strike Follower?

Learn how to setup follow up action on door strike using door strike follower

Archa K avatar
Written by Archa K
Updated over a week ago

Door strike follower allows admins to setup a following action after the door is granted access. To setup a door strike it is important that door contacts are already in place.

Once the admin has created a door and attached a primary or single reader then from the door detail page, the admin can configure the door strike follow. Below are the detail steps :

  1. Navigate to the hardware page and select a desired door

  2. Scroll down to the door strike follower area. Click the edit button and enable the door strike

  3. You can now also change the delay or pulse value

  4. Click on save. Door strike follower is now enabled

Did this answer your question?