How to Configure Access Control Hardware for Use with Genea
Configuring access control hardware, such as Lenel panels and HID readers, for use with Genea involves specific steps to ensure proper integration. This guide provides an overview of the process, including prerequisites and configuration instructions.
Overview of Access Control Configuration in Genea
Genea supports integration with various access control hardware, including Lenel panels and HID readers. Proper configuration ensures seamless operation and compatibility with Genea's access control system. Below are the steps to configure Lenel panels and HID readers.
Configuring Lenel Panels
To configure a Lenel LNL-X2220/LP1502 panel for use with Genea:
Set the Host IP: Configure the panel's Host IP to the appropriate address required for Genea integration. For example, this may be
mercury-api.sequr.io.Adjust the Retry Interval: Set the retry interval to 20 seconds or as specified for your panel.
Save Settings: Ensure all settings are saved.
Power Cycle the Panel: Restart the panel to apply the new settings.
Note: Configuration steps may vary depending on the OEM version of the panel. A factory reset may be required if specified for your version.
Configuring HID Readers
To configure HID readers and enable OSDP (Open Supervised Device Protocol):
Download the HID Manager Application: Install the HID Reader Manager app on your mobile device.
Create an Account: Sign up for an account within the HID Manager app.
Notify Your Administrator: Inform your administrator that your account is ready.
Receive an Invitation: Your administrator will send you an invitation and issue a Genea Mobile Key.
Note: The Genea Mobile Key is required to access and manage HID readers.
Troubleshooting and Additional Notes
Ensure that all firmware and software are up to date before starting the configuration process.
If issues persist, consult the hardware's user manual or contact Genea support for assistance.
For Lenel panels, double-check the Host IP and retry interval settings if the panel fails to connect.
For HID readers, verify that the Genea Mobile Key has been issued and is active.
By following these steps, you can successfully configure Lenel panels and HID readers for use with Genea's access control system.